Acoustic Leak Tracing
We use ground microphones and electronic listening equipment to trace the sound of pressurized water escaping below the slab.
Protect your foundation before it's too late
Slab Leak Detection in Stillwater You Can Trust
A slab leak hides under your foundation, often for months, before it ever shows on the surface. Leak Radar uses acoustic listening equipment and thermal imaging to pinpoint the exact location of a slab leak in Stillwater homes, without guesswork or unnecessary demolition.
Careful work. Honest options.
About this service
What Is Slab Leak Detection?
Slab leak detection locates a break in the water or sewer lines running underneath your home's concrete foundation without tearing up your floors to find it. We combine electronic listening devices, line pressure testing, and thermal imaging to trace the leak to a precise spot.
Slab leaks are common in Stillwater's older neighborhoods, where copper supply lines run directly through or under a concrete slab. Left unaddressed, a slab leak can undermine the foundation, warp flooring, and lead to mold under carpet or tile. Early, accurate detection matters.
- ✓ Pinpoint Accuracy Before Any Digging
- ✓ Foundation-Safe Detection Methods
- ✓ Same-Day Diagnostic Reports
- ✓ Licensed Plumbers On Every Call
What's included
What Our Slab Leak Detection Includes
Our slab leak detection service includes acoustic tracing, thermal confirmation, and a written diagnostic report with repair options. No demolition is required just to find the problem.
Thermal Imaging Scan
Infrared cameras reveal the temperature differential a slab leak leaves behind, confirming the location without any demolition.
Pressure & Line Isolation Testing
We isolate hot and cold lines individually to confirm which line is leaking and rule out fixture-side issues.
Written Findings & Repair Options
You receive a marked diagram of the leak location plus repair options: reroute, spot repair, or epoxy pipe lining.
How it works
Our Slab Leak Detection Process
We ask about your water bill history, any warm spots on the floor, and sounds of running water, then schedule a visit.
We isolate your plumbing system and monitor pressure to confirm a leak exists before bringing out detection equipment.
Using ground microphones and infrared cameras, we trace the leak to a specific, marked location on your slab.
We mark the exact spot on your floor and verify the reading from a second angle to avoid unnecessary cutting.
We walk you through your options (spot repair, reroute, or pipe lining) with a clear, written estimate for each.
STEP 01Initial Consultation
We ask about your water bill history, any warm spots on the floor, and sounds of running water, then schedule a visit.
Tools & methods
Tools and Methods for Slab Leak Detection
Electronic Listening Equipment
Ground microphones amplify the faint sound of water escaping a pressurized line beneath concrete.
Infrared Thermal Camera
Detects the subtle temperature difference a leak creates in the slab and surrounding flooring.
Pressure Gauges
Confirms a drop in system pressure consistent with an active leak before we start cutting into anything.
Line Locators
Traces the exact path of supply lines under the slab so repairs target the pipe, not the whole floor.
Real results
Before and after.
Slab Leak Detection
Before: Warm Spot on the Living Room Floor
A homeowner noticed a warm patch on their tile floor and a steadily climbing water bill.
After: Acoustic tracing located a hot-water slab leak within 18 inches of our first reading; a spot repair was completed the same day.
Book this service →
Slab Leak Detection
Before: Unexplained Water Bill Spike
A monthly water bill nearly doubled with no visible leaks anywhere in the home.
After: Pressure isolation testing confirmed a slab leak on the cold line; we traced and repaired it without removing any flooring.
Book this service →
Slab Leak Detection
Before: Cracking Along an Interior Wall
Hairline cracks were spreading along a wall near the kitchen, worrying the homeowner about foundation movement.
After: Detection confirmed a slab leak was saturating soil beneath the footing; repair stopped the movement before it reached structural cost.
Book this service → Problems we solve
Common Problems Solved by Slab Leak Detection
Our slab leak detection services address several common issues faced by homeowners in Stillwater.
Ask a pro →Water pooling on hard flooring with no obvious source
We trace the leak to its exact origin so the right fix is applied the first time.
Rising water bills with no new fixtures or usage
A pressure test confirms whether a hidden slab leak is behind the increase.
Cracking or shifting near a section of foundation
We check whether a slab leak is saturating soil beneath the footing before it becomes a structural issue.
Proof you can check
Trust and Proof of Our Services
- Licensed through the Oklahoma Construction Industries Board
- Insured and bonded for work throughout Payne County
- Every finding documented in writing before repair begins
Customer reviews
What Our Clients Say About Slab Leak Detection
★★★★★
“We had a warm spot on our kitchen floor for weeks before anyone could tell us why. Leak Radar found the slab leak in under an hour and didn't have to tear up half the kitchen to do it.”
LM
Lisa M.Homeowner, Berry Creek
✓ Verified“
★★★★★
“Our water bill jumped almost forty dollars a month. Turned out to be a slab leak under the hallway. The crew marked the exact spot and the repair took one afternoon.”
TR
Tom R.Homeowner, Country Club
✓ Verified★★★★★
“I was worried this meant replacing our whole foundation. The acoustic testing pinpointed one small section and the fix was way less invasive than I feared.”
PK
Priya K.Homeowner, College Gardens
✓ VerifiedCommon signs include a warm spot on your flooring, the sound of running water when everything is off, an unexplained rise in your water bill, or cracks appearing in the floor or nearby walls.
Slab leak detection in Stillwater typically runs $200 to $500, depending on how accessible the plumbing is and whether both hot and cold lines need to be tested.
Not for detection. We use acoustic and thermal equipment to narrow the leak to a specific, marked spot first. Cutting is only needed once we move to the repair itself.
In almost every case, yes. Most slab leaks are fixed with a targeted spot repair, a rerouted line, or an epoxy pipe lining. Full foundation work is rarely necessary.
Ready when you are
Get Slab Leak Detection in Stillwater Today
A slab leak only gets more expensive to fix the longer it runs. Call now for accurate, non-invasive detection and a clear repair plan.
Schedule Your Appointment (405) 872-2665 →
Request an appointment
Contact Us for Leak Detection
Reach out to us for any leak detection needs. We respond quickly and are available for consultations during business hours.
Call anytime(405) 872-2665Email the officeinfo@leakdetectionstillwaterok.online
Office hoursOpen 24 hours · 7 days a week